 |
Priority Emergency Service - Nobody can get
you back on-line faster. |
|
- 24 hours
service - you make only one call
- Fully stocked
trucks - we have the parts you need or will get them quickly
to minimize downtime
- Knowledge of
your electrical system - our experience with your system
reduces your cost
|
 |
Energized Preventive Maintenance -
Diagnostic testing and most of the critical preventive maintenance is
performed with the system energized. |
|
- Infrared,
harmonics, true RMS, power factor and ultrasonic tests -
catastrophic failures, hazards and fire risks can be reduced
- Visual
Inspection - hazardous conditions can be detected by the
professional
- Insurance
- preventive maintenance exceeds insurance requirements, holding
down premiums
- Hot spots
- eliminating hot spots reduces your energy cost
|
 |
De-Energized Preventive Maintenance - It is
very important to schedule downtime and perform essential tasks on all
electrical equipment and components. We have the resources to perform
the work swiftly and correctly. |
|
- Inspect and
retorque connections - eliminates high resistance connections
that waste energy and pose a fire hazard
- Clean and
vacuum components - eliminates risk of electrical explosion
- Resistance test
(Megger) bus bars, cable and motor windings - prevents
outages due to faults
|
 |
Switchgear Maintenance - Electrical
Construction and Maintenance Magazine published the following
quote in their January, 1995 issue.
"Switchgear
installed by contractors in the late 60s and 70s to meet the
increasing load demands of industry began to fail in the 80s and
90s. These failures have been documented and are available in the IEEE
and Doble Engineering Minute reports. This failure trend
will continue in spite of state-of-the-art changes in construction
techniques and installation methods unless preventive maintenance
steps are taken."
|
 |
Infrared Testing and Reporting - Infrared
testing detects loose connections, current overload and defective
insulators that cause safety hazards and outages. |
|
- Certified TEGG
electricians - provide reliable test result interpretation
- Energized tests
- equipment remains in operation
- Insurance
- meets insurance requirements and may reduce your premium cost
- Predictive
Maintenance - replace before failure
- Documentation
- document deficiencies to enable remedial action
|
 |
Harmonics Testing and Reporting - Computers,
copiers, electronic lighting ballasts, UPSs, elevators and variable
speed drives create harmonics. |
|
- Test and report
level contamination - reduce life safety hazards and downtime
risks
- Watt-hour meter
errors - minimize electric meter errors and reduce your
electrical cost
- Computer memory
loss - memory loss is a costly business disruption
- Energy waste -
preventing the overheating caused by harmonics will reduce energy
bills
|
 |
Power Factor Testing and Reporting - Power
factor should be measured and addressed to avoid unnecessary expense.
We have the solution for you. |
|
- Existing power
factor correction - confirm proper operation of capacitors
- Test and report
- recommend cost savings actions
- Expand capacity
- add capacity without changing your electrical service
|
 |
Typically Maintained Electrical
Components
- auto
transfer switch (ATS)
- branch
circuit breaker panel
- bus duct
- cable
testing
- capacitor/power
factor correction
- disconnect/safety
switch
- distribution
panel
- emergency
generator
- emergency
lighting/exit sign
- high
voltage testing
- indoor/outdoor
lighting
|
- motor
control center
- motor
starter
- motor AC/DC
- power
conditioner
- power
distribution unit
- production
machinery
- switchgear
- transformer
- uninterruptible
power supply (UPS)
- variable
speed drive
- wire
trough/cable tray
|
|
TEGG Corporation is a partnership that is 1/3 owned
by Sargent Electric (Pittsburgh, Pennsylvania.), 1/3 owned by Johnson
Controls, Inc., and 1/3 owned by Hartford Steam Boiler Insurance Co.
TEGG Service is distinguished by its professional and efficient dedication to
serving its customers. TEGG Service enhances its customers' productivity and
profitability by reducing business and facility downtime as well as the cost
of owning and operating facilities.
